The Model 7000 and 7008 Low Noise differential Preamplifiers provide high gain amplification to 1MHz with an AC output derived from a very low noise FET instrumentation amplifier. Each model  has fixed gain settings of x1 (0dB), x10 (20dB), x100 (40dB) and x1000 (60dB) over selectable bandwidths of 100Hz, 1kHz (HP), 3kHz, 30kHz, 100kHz and 1MHz (7000 model only). Noise referred to input is 7nVHz and common mode rejection is >100dB at 1kHz. Momentary pushbutton switches are provided that control coupling, bandwidth, gain and channel on/off selections. BNC connectors are provided for single-ended and differential input, ac output, and dc output (optional) connections.

The Model 7008 eight channel Low Noise Differential Preamplifier offers up to 8 channels of high gain pre-amplification with USB or LAN remote control.

The Model 7000 and 7008 are very useful for troubleshooting sources of noise, amplifiers, power supplies and various other electronic circuits. They are an excellent tool as a preamp for amplifying low level input signals to oscilloscopes or other devices.
Model 7000
Model 7008
• Noise (RTI): 7nV/Hz
• Gain Settings: x1, x10, x100 and x1000
• Amplitude Flatness: ±0.3dB
• Output: ±10V Peak
• Selectable Bandwidth: 100Hz, 3kHz, 30kHz,
  100kHz and 1MHz (LP Off)
• CMRR: >100dB at 1kHz
• Optional RMS-to-DC Output
• Gain Settings: x1, x10, x100 and x1000
• Noise (RTI): 7nV/
Hz
• Amplitude Flatness: ±0.3dB
• Output: ±10V Peak
• Selectable Input Configurations: Differential, +SE, -SE and OFF
• Selectable Input Shunts: 50, 500, 5k and 50k Ohms
• CMRR: >100dB at 1kHz
• Optional Remote Programming: USB or LAN
Data Sheet
Operating Manual
Single Channel General Purpose
Eight Channel Remote Controlled
Data Sheet
Operating Manual


Copyright © Krohn-Hite Corporation. All rights reserved.
Call
508-580-1660
"Quality" In Test and Measurement
Since 1949

Low Noise Preamplifiers